Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Cap & Crown Cost in East Flatbush?
Chimney cap and crown work in East Flatbush typically runs $385 to $850 for a standard cap installed on a single-flue chimney, while crown repair or rebuild usually falls between $450 and $1,400 depending on how much masonry has to come out. A full crown replacement on a wide brick chimney is the higher end of that range; a simple cap swap is the lower. Both prices are estimates for this market, and the written estimate you get before work begins sets the final number.
Those ranges assume a chimney that’s sound below the roofline. Once a technician gets on the roof and finds spalling brick, a cracked flue tile, or a crown that’s separated from the stack, the scope changes and the estimate changes with it. That’s not a sales tactic – it’s how masonry behaves on the flat-roofed rowhouses and low-pitch colonials that make up most of East Flatbush’s housing stock.
We work with Gelco and Famco cap components and the same professional-grade materials certified chimney specialists rely on nationwide. If you want a firm number rather than a range, call (844) 932-2112 for a free estimate. We answer 24/7.
Key Takeaways
- A standard single-flue chimney cap installed in East Flatbush: $385 to $650.
- Custom or multi-flue caps for wider stacks: $550 to $850.
- Crown repair (crack sealing, patching): $450 to $750.
- Full crown rebuild with new mortar and overhang: $850 to $1,400.
- Cap and crown done together is almost always less than two separate visits.
- A chimney inspection before the work tells you which of these you actually need.
Chimney Cap & Crown Cost Breakdown (2026)
Here’s how the line items shake out for East Flatbush in 2026. These are typical installed prices – materials plus labor plus the roof work – not material-only figures.
| Line Item | Typical Range (Installed) | What It Covers |
|---|---|---|
| Standard single-flue cap (Gelco or Famco) | $385 – $650 | Galvanized or stainless cap, mesh, and mounting hardware sized to the flue |
| Multi-flue or oversized cap | $550 – $850 | Custom-width cap for wider masonry stacks and double-flue chimneys |
| Stainless steel upgrade | Add $80 – $200 | Longer service life in freeze-thaw conditions compared with galvanized |
| Crown crack sealing / patching | $450 – $750 | Cleaning, filling hairline cracks, and flexible sealant over sound masonry |
| Partial crown rebuild | $650 – $950 | Removing a failed section and re-pouring with proper slope and overhang |
| Full crown replacement | $850 – $1,400 | Complete removal, new form, new crown with drip edge, curing time included |
| Cap and crown together | $790 – $1,750 | Both jobs on one visit, one roof setup |
| Standalone chimney inspection | $150 – $350 | Condition report on crown, cap, flue, and flashing – usable for insurance or a sale |
Two things push these numbers around more than anything else. First is access: a chimney on a flat rowhouse roof is a different job than one on a steep gable where a technician needs ladder staging and roof anchors. Second is what’s underneath. A crown that looks like a simple crack from the sidewalk can turn out to be sitting on a wash that’s already failed, and at that point patching is throwing money at a problem that comes back in two winters.
If your chimney needs both a new cap and structural masonry attention below the roofline, we also handle chimney repair as a separate scope so you’re not coordinating a mason and a sweep on the same stack.
What Affects Chimney Cap & Crown Pricing in East Flatbush
- Roof type and pitch. East Flatbush has a lot of flat-roofed and low-pitch rowhouses along the Nostrand Avenue and Church Avenue corridors, and those are the easier, cheaper setups. A steep-pitch gable roof on the older detached homes east of Flatbush Avenue needs staging, which adds labor.
- Chimney width and number of flues. A single 8-inch flue takes a stock-size Gelco or Famco cap. A wide stack with two or three flues needs a custom-width cap, and that’s where you cross into the $550 to $850 band.
- How far the crown has failed. Hairline cracking is a sealant job. A crown with no overhang, no drip edge, and crumbling mortar at the edges is a rebuild – it has to come off, a new form goes on, and the new crown gets the slope it should have had originally.
- Freeze-thaw cycles. New York winters drive water into every crack, it freezes overnight, expands, and widens the crack. A crown that would last years in a mild climate can degrade in a few seasons here. That’s the real reason crown work is worth doing properly rather than patching.
- Condition of the brick below the crown. If the top courses are spalling, the crown can’t be rebuilt on soft brick – those courses come out first. That’s an add, and it shows up in the estimate before anyone starts, not halfway through.
- Whether an inspection has been done. Walking onto a roof without knowing the flue condition means a surprise mid-job. A pre-work inspection prices the whole scope up front.
One more local factor worth naming: the dense housing here means chimneys sit close to neighboring rooflines and parapets. On some East Flatbush blocks, a technician has to work around shared walls and tight setbacks, and that takes time. It’s not a big line item, but it’s real, and it’s the kind of thing a company pricing from a photo alone will miss.
Cap vs. Crown: What You’re Actually Paying For
Homeowners often use the two words interchangeably, and they’re not the same part. The cap is the metal or stainless cover that sits on top of the flue and keeps rain, birds, squirrels, and downdrafts out. The crown is the concrete or mortar slab at the very top of the chimney that sheds water away from the brick below it.
They fail differently. Caps get dented, rust through, or get torn off in wind. Crowns crack, separate from the stack, and let water soak into the masonry, which then fails in a freeze. A bad cap lets water straight down the flue. A bad crown lets water into the brick itself, which is the more expensive failure.
That’s why we stock Gelco and Famco cap solutions rather than ordering and rescheduling. Cap sizing, material choice, and fit get settled at the job site while the technician has the flue measured in front of them. For crown work, the material choice matters less than the shape – slope and drip edge do most of the waterproofing work, and a crown poured flat without them fails again.
If you’re trying to figure out which one you need, a standalone chimney inspection gives you a condition report you can act on. We treat it as its own service, not a checkbox at the end of a sweep, because homeowners use that report for insurance claims, real estate transactions, and repair planning.
How to Save on Chimney Cap & Crown
There’s no coupon here. The savings come from sequencing the work correctly and not paying for a second visit.
- Do the cap and the crown on the same visit. The roof setup is a large share of the labor on both jobs. Combining them typically saves the equivalent of most of a second trip.
- Get the crown before the cap when both have failed. Water getting into brick does more damage than water going down a flue. Rebuilding the crown and capping the same day protects the work you just paid for.
- Handle cracking early. Crack sealing at $450 to $750 is cheaper than a rebuild at $850 to $1,400. The catch is catching it before the crown separates.
- Ask for a written condition report. Knowing the full picture on the crown, cap, flue, and flashing means you can plan the spend instead of reacting to it, and you won’t pay for an inspection twice.
- Skip the stainless upgrade if you’re moving soon; get it if you’re staying. It adds $80 to $200 up front and pays back over the life of the cap.
On liner issues found during cap and crown work, HeatShield resurfacing can restore a damaged liner without the cost of full replacement through a reliner. We apply the same HeatShield system used by certified chimney specialists, and in many cases it’s the difference between a repair and a four-figure rebuild. The full scope of what we handle on the stack above the roofline is on our chimney cap & crown page.
Estimates are free, and they’re written rather than quoted over the phone. Call (844) 932-2112 for a free estimate, and we’ll tell you exactly what we find and what it means before any work begins.
What Happens When You Call
You describe what you’re seeing – water staining on the ceiling, a cap that’s gone, mortar on the roof, or nothing at all and you just want the stack checked before winter. We book an inspection and get a technician on the roof. Photographs of the crown, cap, flue, and flashing come back with the written estimate, and the estimate separates cap work from crown work from any masonry below the crown.
If the job is a straightforward cap or crown repair, it’s often done the same day as the inspection. Rebuilds get scheduled once the material is confirmed. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Our technicians have up to 12 years of experience on chimney systems, and we cover the full lifecycle – sweep, inspection, cap and crown, chimney repair, and fireplace repair. One call covers the whole stack, so you’re not hiring a second company for something found during the first visit. The work is completed by state-licensed, insured local professionals.
FAQs – Chimney Cap & Crown Cost
How much does a chimney cap cost in East Flatbush?
A standard single-flue chimney cap installed in East Flatbush costs $385 to $650, with custom or multi-flue caps running $550 to $850. Stainless steel instead of galvanized adds $80 to $200. Those are installed prices for this market; the written estimate sets the final figure. Call (844) 932-2112 for an exact quote – estimates are free.
How much does chimney crown repair cost in East Flatbush?
Crown repair in East Flatbush runs $450 to $750 for crack sealing and patching, and $850 to $1,400 for a full rebuild with a new form, slope, and drip edge. A partial rebuild on a section that’s failed sits in the $650 to $950 range. Whether you need a patch or a rebuild depends on how much the crown has separated from the stack. Call (844) 932-2112 for an exact quote – estimates are free.
Is it cheaper to repair the crown or replace it?
Repairing a crown is cheaper at $450 to $750 versus $850 to $1,400 for replacement, but only when the crown still has a sound shape and slope. A crown that’s lost its overhang or separated from the brick has to be replaced, because patching a flat, water-holding crown just postpones the same failure. An inspection tells you which case you’re in. Call (844) 932-2112 for an exact quote – estimates are free.
Do I need a chimney cap and a crown?
Yes, and they do different jobs. The cap keeps rain and animals out of the flue; the crown sheds water off the top of the brick. A chimney with one and not the other is still taking on water. Doing both on the same visit typically costs $790 to $1,750 and saves the labor of a second roof setup. Call (844) 932-2112 for an exact quote – estimates are free.
Can you install a chimney cap today in East Flatbush?
Often yes, if the cap size is confirmed on-site and it’s a standard single-flue installation. We carry Gelco and Famco cap components so sizing and fit are settled at the job rather than ordered and rescheduled. Call (844) 932-2112. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Does a chimney cap or crown repair need a permit in East Flatbush?
Cap installation generally doesn’t require a permit; a full crown rebuild may, depending on how much masonry is involved. Most cities require a permit for structural masonry work, so ask your city’s building department before the job is scheduled and confirm what the contractor is responsible for pulling. Call (844) 932-2112 for an exact quote – estimates are free.
Getting a Real Number
Pricing a cap or crown from the ground doesn’t work. The number depends on the flue count, the crown’s condition, the roof setup, and what the brick underneath is doing – and four of those need someone on the roof to see. That’s why the estimate is free and written, not quoted over the phone.
One call covers sweep, inspection, cap, crown, and repair. We work with the same materials certified chimney specialists rely on nationwide, including DuraFlex, Olympia Chimney, and Copperfield components for the liner and venting work that often surfaces once the cap comes off. To get your chimney looked at properly, go back to Chimney Sweep East Flatbush for the full service list, or call (844) 932-2112 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the East Flatbush market as of 2026. Chimney Sweep East Flatbush offers free estimates – call (844) 932-2112.
Written by the team at Chimney Sweep East Flatbush.
What Our Customers Say
"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
- Marcus Coleman"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
- Renee Brooks"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Holly Kowalski